|
March 14th, 2024, 08:57 PM
|
#1 |
|
ninjette.org newbie
Name: Mustafa
Location: Ohio
Join Date: Mar 2024 Motorcycle(s): 2005 Ninja ex250 Posts: 7
|
Idle Mixture Screws
Recently bought new OEM carburetors and have cleaned them, before I put them into the bike I was wondering if anyone knew how much I should turn my idle mixture screws.
|
|
|
|
March 14th, 2024, 09:46 PM
|
#2 |
|
ninjette.org newbie
Name: Cody
Location: Hayesville
Join Date: Mar 2024 Motorcycle(s): 2007 ninja ex250r Posts: 6
|
All the way in and 2 1/2 out is what I have mine set too since kawasaki likes to lean the bikes to make them more eco friendly
|
|
|
|
|
March 15th, 2024, 05:31 AM
|
#3 |
|
Guy Who Enjoys Riding
Name: Jim
Location: North Carolina
Join Date: Jul 2016 Motorcycle(s): Ninja 250 Posts: A lot.
MOTM - Oct '18, Aug '17, Aug '16
|
They need to be set for highest idle speed. Erring a tiny bit on the rich side is better than on the lean side. @ducatiman may have some additional relevant advice.
Why did you clean new OEM carburetors? Welcome to the board, Mustafa! |
|
|
1 out of 1 members found this post helpful. |
|
March 15th, 2024, 06:35 AM
|
#4 |
|
ninjette.org newbie
Name: Mustafa
Location: Ohio
Join Date: Mar 2024 Motorcycle(s): 2005 Ninja ex250 Posts: 7
|
Thank you guys for the info, couldn’t find it anywhere else. The reason i cleaned then was because the seller recommended it before installing it into the bike.
|
|
|
|
|
March 15th, 2024, 09:21 AM
|
#5 | |
|
Guy Who Enjoys Riding
Name: Jim
Location: North Carolina
Join Date: Jul 2016 Motorcycle(s): Ninja 250 Posts: A lot.
MOTM - Oct '18, Aug '17, Aug '16
|
Quote:
|
|
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY - Accessing and adjusting idle mixture screws | VeX | 2008 - 2012 Ninja 250R Tech Talk | 71 | December 15th, 2017 03:38 AM |
| Pilot jets and idle mixture screws won't screw in | rustyshackelford | 1986 - 2007 Ninja 250R Tech Talk | 10 | September 19th, 2017 03:44 PM |
| Idle mixture screws are at different heights? (Idling/Starting Problem) | MegaEgg | 1986 - 2007 Ninja 250R Tech Talk | 30 | March 6th, 2016 10:37 AM |
| Question about adjust idle mixture screws | daverdfw | 2008 - 2012 Ninja 250R Tech Talk | 14 | February 28th, 2016 05:34 PM |
| adjusting idle mixture screws | james250ninja | 1986 - 2007 Ninja 250R Tech Talk | 9 | September 1st, 2014 10:29 AM |
| Thread Tools | |
|
|
