January 7th, 2023, 09:08 AM | #1 |
ninjette.org member
Name: Mike
Location: Connecticut
Join Date: Nov 2022 Motorcycle(s): ‘04 EX250 Posts: 157
|
Ninja 300 clip on for clutch
I searched but I didn’t see anything about it.. so I got replacement brake and clutch levers however the clutch the opening is lower than the one on the bike (I assume it’s from the EX 500. Since because of that I was wondering if the one from the new gen 300 would fit?
|
|
January 15th, 2023, 09:03 AM | #2 |
ninjette.org member
Name: Mike
Location: Connecticut
Join Date: Nov 2022 Motorcycle(s): ‘04 EX250 Posts: 157
|
Ok I got it I didn't take in account of the ex500 had a two clamp where this one is a slip on.
|
|
January 15th, 2023, 05:09 PM | #3 |
ninjette.org member
Name: Mike
Location: Connecticut
Join Date: Nov 2022 Motorcycle(s): ‘04 EX250 Posts: 157
|
For everyone it works fine and the clutch lever works
|
1 out of 1 members found this post helpful. |