|
September 1st, 2011, 05:53 PM
|
#1 |
|
Dakine...
Name: AJ
Location: DFW
Join Date: Jun 2011 Motorcycle(s): 2009 Ninja 250R (Sold) | 636 (hopefully soon) Posts: A lot.
Blog Entries: 5
|
Quick shim question
So I decided to remove the rubber thing to get to the needles.i was not paying attention. There is two holes..one for the needle and another smaller one. Which way do I put it back? With the second hole facing the front or back of the bike?...thanks all
Posted via Mobile Device |
|
|
|
September 2nd, 2011, 02:43 PM
|
#3 |
|
Smoker
Name: Bob
Location: SoCal
Join Date: Dec 2010 Motorcycle(s): Guess.... Posts: 556
|
You can only put the slides back in one way. Rather, they will only fit one way.
|
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carb Needle Shim Question/Bike Idle | haloninja117 | 1986 - 2007 Ninja 250R Tech Talk | 3 | August 8th, 2014 01:14 PM |
| shim kit question | mikedabike64 | 2008 - 2012 Ninja 250R Tech Talk | 15 | November 4th, 2013 06:04 AM |
| general shim under bucket question | mikedabike64 | 2008 - 2012 Ninja 250R Tech Talk | 6 | September 30th, 2013 11:09 AM |
| Fuel Mixture Question - Shim or Jet for this set-up? | folky15 | 2008 - 2012 Ninja 250R Tech Talk | 20 | April 23rd, 2012 06:21 PM |
| Quick Shim question | shadowskater | 2008 - 2012 Ninja 250R Tech Talk | 7 | February 28th, 2011 08:41 PM |
|
|
...i must have done it right then....slid right in..tnx
