pre gen 15t sprocket on 08+ ninja?

Graugaard · April 24th, 2012, 02:48 AM

"OH NO its the 15t topic again"

Got a little question before i order. I can save like 40$ if the old sprocket works, where i live the shipping cost is very high for the "JT Sprockets JTF1539.15" for some reason.

As far as i know, the only difference between old and new is 2 small holes on the sprocket, which the old one used for extra security. So wouldn't this one work as well: Ninja 06-07 sprocket

grats.

CZroe · April 24th, 2012, 04:40 AM

It's about 2mm thinner on one side. You can order and add a washer or two for exact alignment, but most people are OK using it without a shim/washer. There's one with all the little tabs that fits on the shaft in the Ninjette's parts fiche.

April 24th, 2012, 02:48 AM	#1
Graugaard ninjette.org member Name: Elias Location: Denmark Join Date: Nov 2011 Motorcycle(s): Ninja 250r Posts: 152	pre gen 15t sprocket on 08+ ninja? "OH NO its the 15t topic again" Got a little question before i order. I can save like 40$ if the old sprocket works, where i live the shipping cost is very high for the "JT Sprockets JTF1539.15" for some reason. As far as i know, the only difference between old and new is 2 small holes on the sprocket, which the old one used for extra security. So wouldn't this one work as well: Ninja 06-07 sprocket grats.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
JT 15T new gen sprocket installed incorrectly??	raytwotimes	2008 - 2012 Ninja 250R Tech Talk	4	June 19th, 2014 06:36 PM
Sprocket comparability pre gen to new gen	Rollingmenace	1986 - 2007 Ninja 250R Tech Talk	16	October 29th, 2013 10:22 PM
15t Sprocket Noise	ChickenRun	2008 - 2012 Ninja 250R Tech Talk	5	August 18th, 2013 12:58 PM
FS: Pre-gen JT 14T Front Sprocket, $8 Shipped	menikmati	Motorcycle-related	2	February 4th, 2013 10:05 AM
15t Sprocket Brands	lonewolf05	2008 - 2012 Ninja 250R Tech Talk	5	March 4th, 2011 09:39 PM

April 24th, 2012, 04:40 AM	#2
CZroe CPT Falcon Name: J.Emmett Turner Location: Newnan, GA Join Date: Apr 2009 Motorcycle(s): '08 CP Blue EX250J, '97 unpainted EX250F, 2nd '97 unpainted EX250F (no engine), '07 black EX250F Posts: A lot.	It's about 2mm thinner on one side. You can order and add a washer or two for exact alignment, but most people are OK using it without a shim/washer. There's one with all the little tabs that fits on the shaft in the Ninjette's parts fiche.