February 23rd, 2012, 02:27 PM | #1 |
OMRRA 701
Name: .
Location: PDX
Join Date: Jan 2012 Motorcycle(s): 'jette, R6 Posts: 96
|
EX250R stock fork height
Can anyone tell me the stock fork height for second gen bike? Have searched for that number and all I can find are the spec hieght for first gen bike, which apparently is 10mm of space between the top of the triple tree and the fork cap (That measurement is not from the service manual so don't quote me on it).
Can't find a service manual online so if anyone holding one could check and let me know I'd be most grateful. thanks kangxi |
|
February 23rd, 2012, 03:34 PM | #2 |
ninjette.org certified postwhore
Name: .
Location: .
Join Date: Feb 2011 Motorcycle(s): . Posts: Too much.
MOTM - Feb '13, Feb '14
|
Are you looking to put them back on the triples? Just slide them up until they bottom out in the risers. They only go up so far. It's not like with clipons where you have to keep track of how high the forks were when you take them off.
|
|
February 23rd, 2012, 03:50 PM | #3 | |
OMRRA 701
Name: .
Location: PDX
Join Date: Jan 2012 Motorcycle(s): 'jette, R6 Posts: 96
|
Quote:
Anyone have any thoughts on this or on front end geometry for EX250 race bikes? |
|
|
February 23rd, 2012, 04:00 PM | #4 |
ninjette.org certified postwhore
Name: .
Location: .
Join Date: Feb 2011 Motorcycle(s): . Posts: Too much.
MOTM - Feb '13, Feb '14
|
On a stock bike, they only go up as far as the risers will allow. But people have dropped the front end so there's an inch or so above the triple without problems.
This thread might be of some help. |
|
February 23rd, 2012, 05:51 PM | #6 |
OMRRA 701
Name: .
Location: PDX
Join Date: Jan 2012 Motorcycle(s): 'jette, R6 Posts: 96
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Should float height stay stock after rejetting? | agentbad | 1986 - 2007 Ninja 250R Tech Talk | 3 | July 6th, 2014 10:44 AM |
stock fork height over triple tree | Lychee | 1986 - 2007 Ninja 250R Tech Talk | 10 | August 30th, 2013 01:12 PM |
Anyone know the stock fork spring rate? | Rizod | 2008 - 2012 Ninja 250R Tech Talk | 8 | April 10th, 2012 05:42 PM |
Raise rear back to stock height | EddieNewYork | 2008 - 2012 Ninja 250R Tech Talk | 11 | July 15th, 2011 03:18 PM |
[sportrider - latest stories] - Ask the Geek: Fork Oil Height and Stone-Age Tires | Ninjette Newsbot | Motorcycling News | 0 | May 28th, 2010 10:30 AM |
|
|