|
December 26th, 2008, 03:49 PM
|
#1 |
|
IC2(SW)
Name: Kerry
Location: Pensacola
Join Date: Nov 2008 Motorcycle(s): . Posts: A lot.
|
3rd Gen Camaro (firebird) ZF6 Speed Conversion Kit
Turn your 3rd Gen Camaro (firebird) into a 6 Speed
 1000 OBO  You get: Corvette ZF6 Speed & Bell Housing (39,000 mile + or -) ZF6 Trans Yoke < Fits stock Aluminum 82-92 drive shaft. LT4 Clutch/Pressure Plate & Fly Wheel - new ZF6 Fly Wheel - used TTA Trans Cross member Two set's of Brake/Clutch Pedals Camaro Master Cylinder Corvette & Camaro Slave Cylinders Pilot Bearing & Throw Out Bearing - new Camaro center console plate - new ZF6 shift knob - new All you need to complete the install is: Hydralic line - (to hook up to either kind of slave cylinder vette or camaro) Modify your stock tourque arm < or get the Jeg's one. Would like for you to pick this stuff up! Could deliver within 300 miles or so.... Or you arrange shipping/pick up after funds have cleared 
Last futzed with by HKr1; December 26th, 2008 at 05:10 PM. Reason: info |
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3rd gen 4th gen Hybrid | Retro Ninja | 1986 - 2007 Ninja 250R Farkles | 20 | July 20th, 2015 06:29 PM |
| my 3rd pre-gen spanning 18 years | speedgsx98 | General Motorcycling Discussion | 5 | March 21st, 2011 10:02 PM |
| HID Conversion for Pre-Gen on Ebay/Link.. | cnichols79us | 1986 - 2007 Ninja 250R Tech Talk | 4 | March 13th, 2010 07:25 PM |
| 3rd gen vs 4th gen question | Choter | 2008 - 2012 Ninja 250R Tech Talk | 1 | December 31st, 2009 05:31 PM |
| 3rd Gen Camaro/Firebird ZO6 Brake Kit | HKr1 | Miscellaneous | 11 | April 4th, 2009 10:23 AM |
|
|
