November 13th, 2009, 09:30 AM | #1 |
ninjette.org member
Name: Jonathan
Location: Northridge
Join Date: Oct 2009 Motorcycle(s): 2003 Ninja 250 Posts: 17
|
best way to seat the air box to carbs.
I took my carbs out to clean them and the bike has not been running good. I set the mixture screws to 2.5 out and set the idle after warmed up. once i rev the engine it hangs and wont come down. I lubed the cables and it snaps back fine. I noticed that the airbox and the little round rubber/spring seals that are seated close to the carb intake side, are not fully sealed to the intake side of the carbs. I tried to slide the airbox closer, but it just wont go any further closer to the carbs. Any ideas?
I was thinking of drilling new holes below the battery so that I can push the airbox further forward, then tighten the screws below the battery. I believe this is my issue of hanging idle. Jonathan aka fixture |
|
November 13th, 2009, 10:12 AM | #2 | |
Live Life
Name: Don
Location: Lincoln, NE
Join Date: Nov 2008 Motorcycle(s): 2009 Green SE Ninja 250 Posts: A lot.
|
Jonathan - take a look at Kelly's post on this issue.
Quote:
__________________________________________________
- ATGATT - Scorpion EX700 Hi-Vis Helmet, First Gear MeshTek 3.0 Jacket, TourMaster Transition 2 Jacket and Flex Pants, Sidi Doha boots |
|
|
November 13th, 2009, 02:18 PM | #3 |
North Alabama Mtn. ryder
Name: Nate
Location: Alabama
Join Date: May 2009 Motorcycle(s): 2006 Posts: 537
|
spend 60 bucks
and see pod thread and 10 bucks for main jets and a couple flat washers and see jetting thread
__________________________________________________
QTRltrPWR |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Please help, oil in air box. | gregoryl | 1986 - 2007 Ninja 250R Tech Talk | 2 | September 19th, 2014 07:01 PM |
air box | John D | 1986 - 2007 Ninja 250R Tech Talk | 10 | September 4th, 2012 08:07 PM |
K&N air filter to stock air box | Graugaard | 2008 - 2012 Ninja 250R Tech Talk | 29 | July 28th, 2012 06:33 AM |
Air box clamps | haze5736 | 1986 - 2007 Ninja 250R Tech Talk | 1 | July 9th, 2011 04:16 PM |
Air box removed, now.... | cbowman78 | 2008 - 2012 Ninja 250R Tech Talk | 6 | December 15th, 2010 08:11 AM |
|
|