|
February 1st, 2018, 12:45 PM
|
#1 |
|
ninjette.org newbie
Name: Patrick
Location: Cleveland
Join Date: Feb 2018 Motorcycle(s): 07 250r Posts: 2
|
'07 250r header/exhaust
Hello,
Curious if anyone knows if the gen 2 ('08) headers/exhaust would fit on the gen 1 ('07). Trying to go 2 into 1. Thank you. |
|
|
|
February 1st, 2018, 01:09 PM
|
#2 |
|
????????????????
Name: T
Location: no where
Join Date: Feb 2016 Motorcycle(s): 2007 ninja 250, 14 ninja 300, 09 1125CR Posts: A lot.
MOTM - May '17
|
I know it been discussed before and from what i remember is that the header gap/distance between the to pipes going into the head are different. So short answer is no.
|
|
|
|
|
February 1st, 2018, 01:12 PM
|
#3 |
|
????????????????
Name: T
Location: no where
Join Date: Feb 2016 Motorcycle(s): 2007 ninja 250, 14 ninja 300, 09 1125CR Posts: A lot.
MOTM - May '17
|
Muzzy and area p exhaust use to make single side after market ones but now can only find used and were louder
|
|
|
|
|
February 1st, 2018, 02:58 PM
|
#4 |
|
ninjette.org certified postwhore
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot.
MOTY - 2018, MOTM - Nov '17
|
It can be done, but you'll need to cut the header pipes off the collector as well as remove the H-pipe joint. Rotate the header pipes to fit different exhaust-port spacing. Weld back onto collector. Weld H-pipe joiner back in.
|
|
|
|
|
February 2nd, 2018, 05:13 AM
|
#5 |
|
ninjette.org newbie
Name: Patrick
Location: Cleveland
Join Date: Feb 2018 Motorcycle(s): 07 250r Posts: 2
|
Thank you.
|
|
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what am i missing, 95 250R exhaust header bolt up questions (stock) | macantley | 1986 - 2007 Ninja 250R Tech Talk | 13 | May 19th, 2014 01:08 AM |
| Thread Tools | |
|
|
