October 7th, 2014, 05:14 PM | #1 |
ninjette.org guru
Name: Josh
Location: Kern
Join Date: Dec 2013 Motorcycle(s): '04 Ninja 250R Posts: 367
|
Rpms won't go any lower than 2k ....
So I removed my evap system. Ever since then after the bike is warmed up it won't go any lower than 2k Rpms. I even tried adjusting the idle switch. Any ideas?
|
|
October 7th, 2014, 07:28 PM | #2 |
Rev Limiter
Name: Jay
Location: WI
Join Date: Jul 2013 Motorcycle(s): '06 SV650n, '00 Derbi GPR, '64 CA77 Dream 305, '70 CL450 Scrambler, numerous dirt bikes Posts: A lot.
MOTM - Jun '18, Oct '16
|
Open vacuum line?
|
|
October 8th, 2014, 06:24 AM | #3 |
ninjette.org member
Name: John
Location: Milford, CT
Join Date: Mar 2014 Motorcycle(s): 2003 Ninja 250r Posts: 212
|
Check your throttle cables. Make sure they are not binding up or adjusted incorrectly. Check your choke cable. If its not set up right it might be slightly choking your carb which would increase the throttle. Lastly.. check for vacuum leaks around the carb boots to intake and from the carbs to the airbox.
|
1 out of 1 members found this post helpful. |
October 8th, 2014, 06:36 AM | #4 | |
ninjette.org guru
Name: Josh
Location: Kern
Join Date: Dec 2013 Motorcycle(s): '04 Ninja 250R Posts: 367
|
Quote:
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Buzzing noise at lower rpms? | kamikaze | 2008 - 2012 Ninja 250R Tech Talk | 17 | June 30th, 2015 06:36 AM |
Engine Frozen? Won't start, just clicks/whirs and runs up the rpms | ChanceCampbell | 1986 - 2007 Ninja 250R Tech Talk | 11 | May 9th, 2013 07:20 PM |
RPMs | akcalhoun | 2008 - 2012 Ninja 250R Tech Talk | 5 | September 18th, 2012 04:43 AM |
rpms | scottyp | 2008 - 2012 Ninja 250R Tech Talk | 16 | June 22nd, 2009 12:54 AM |
|
|