|
April 17th, 2009, 07:28 PM
|
#41 |
|
ninjette.org member
Name: Nico
Location: Anchorage, Alaska
Join Date: Dec 2008 Motorcycle(s): 08 Ninja 250R Posts: 52
|
i now have the same problem as in post #1, after i did all my mods to carb, exhaust, snorkel.
but i actually believe it could be the choke, as i did my woodcraft clip-ons, and maybe the choke cable got stretched so now the choke is one when the lever on the handlebar is off. I will look into that... feels good riding again!  Edit: def. not the choke, as the cable goes slack when choke is off. My next try will be idle mixture screws, as it is running rich right now (if I rev it, it will bog down below idle and then catch itself back to idle) turn in (clockwise) will lean, opposite richen, am i correct?
__________________________________________________
'08 Ninja 250R: Yoshi Full System, HID's, FP Jet Kit, Snorkel removed, LED Brakelight, LED Footpeg Turnsignals, Zero Gravity SR Windscreen, Fender Eliminator, Solo Seat Cowl, Woodcraft Clip-Ons Last futzed with by ak_907_ak; April 17th, 2009 at 10:00 PM. |
|
|
 |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine idles to a stop after running a few minutes. | MCPhotographer | 1986 - 2007 Ninja 250R Tech Talk | 38 | September 2nd, 2016 08:48 PM |
| After jetting bike idles low? | Mr_ek9 | 2008 - 2012 Ninja 250R Tech Talk | 2 | January 17th, 2015 02:18 PM |
| Bike idles higher when leaned over on kickstand | cuong-nutz | 2008 - 2012 Ninja 250R Tech Talk | 2 | September 25th, 2014 12:24 PM |
| Idles too high I think?? | NinjaRed | General Motorcycling Discussion | 5 | July 9th, 2013 10:18 AM |
| [motorcycle.com] - US Highland Idles Factory | Ninjette Newsbot | Motorcycling News | 0 | January 20th, 2011 02:00 PM |
|
|
