does it matter if the little holes face the back or the front?

TY

Steve

What little holes are you asking about?

The little holes in the bottom next to where the needles go through the diaphragm... Doesn't matter now I faced them towards the air filters and it's running great. TY for the response.

So I know op said his was fine, but is there a correct side for the hole in the bottom of the slide near the needle?

I'm actually kind of curious about this as well. Given the setup I don't think it would make a difference but I made sure the holes pointed towards the sync screw on the carbs like they did when I pulled them out.