- How to replace sprocket with a 15-tooth on 1st gen 250r
- Your Favorite Tires for PreGen
- Missing Shifts?
- Oil change question
- More Ninjette Shifting-long throw
- Performance Specs?
- Chain
- Bike barely runs, HELP!!
- Another tire thread
- Link to 1st-Gen Ninjette Tech information
- Service Manual??
- Rear brake caliper issue
- DIY: Pregen Fender Chop/Flush mount turn signal mod
- DIY: Brake Pedal Replacement
- Coolant Reservoir Level
- Pics of my new rear fender bob...
- Project: Vapor Mod
- Increased rake modification + steering dampener, a possibility? Any reason?
- Rear end squirms under braking.
- Alternate front pegs for your 250...
- "Pre-Gen" Woodcraft Clip-Ons
- Front Fairing Removal?
- Radiator Fan Question
- Exhaust
- place to work
- valve clearance specs
- What others mirrors fit??
- Area P Exhaust
- Rear Wheel Play
- Going back to Stock Pipes
- Official Area-P Pre-08 Ninja 250 Exhaust Thread
- Area P exhaust.
- Mixture Needle Shimming
- '06 250 won't start
- Lighting question on my '07
- "J" series rear shock assembly on "F" series
- Argh! Gas leak from petcock.
- Another question for the gearheads.
- Pirelli Sport Demons
- Question about UNI pods\K&N air filters
- trying to make a decision.
- Rear Tire size ... Go up? Thoughts on this?
- pretty sure i f'd myself...(gas leak)
- 48 Hours of..........
- Loose Gauge Cluster?
- Gas Tank Replacement
- Cold Weather Idle?
- Half Naked!
- So I'm hearing a rattling noise from my engine
- bogging down, help please
- 08/09 J Shock Installed - Initial impressions
- Loud noise in engine
- Checked camshaft tensioner now bike will not run
- Isn't this a cool idea?
- 2008 front forks
- GP Shift.
- Grinding Foot Pegs
- Issue with leaking oil ... no hose on air box ?
- Valve adjustment
- Cover the side covers with ?
- Just picked up a motorcycle/atv jack
- went from 14t sprocket to 15t
- Front Axle Nut
- just mounted Pirelli MT-75's
- Where do I get all the fairing bolts/screws/hardware?
- thoughts on emissions removal
- Died at a light yesterday
- Quick question on brakes and stuff...
- Electrical problem....
- Fork springs... What to replace with?
- What bulbs can I buy that are BRIGHT?
- Replacing CA Fuel Tank
- missing fork clamp bolt
- just dropped the front forks 3mm
- Oil in air box...
- fuel cap issues
- Engines dies in hot afternoon during low RPM ride
- Ninja 250r Wont Rev or run without choke
- ZX600 Rear Shock Question
- Tune up / Restoration questions - long post
- speedometer / odometer disconnected
- 2007 250 Won't Start
- When do you hit reserve?
- ...from bad to worse...my clutch nIgHTmaRE
- pre-gen Muzzy photo wanted
- blown headlight fuse
- crooked steering
- Swapping only the front sprocket.
- Lucas oil
- Oil Sight Glass
- baffle removal
- Muffler removal...
- dent/bend in swing arm???
- liquid/vapor seperator question
- axle nut torque?
- anyone have a dyno run with a muzzy?
- Question on footpeg placement, and controls.
- RPM issues? Best way I could describe it.
- Couple of quick questions
- Unconnected wires
- dies when pulling the clutch
- Valve clearance check/adjustment
- Battery problem?
- Oil Pressure Indicator Question
- Clip-ons....
- Ebay fairings.....
- slight choke cable issue
- stock size jets???
- Rear sprocket, good or bad?
- stock ninja parts at harley dealer
- dynojet kits wrong???
- DIY: Replacing the Clutch Plates
- 'J Shock' Upgrade
- Tire tread
- replacing rear brakes
- I Dropped my feeler gauge down into the Engine!!!!!!
- First oil Change - too much oil??
- Throttle Cable Zip Tie Mod - DIY
- Ordered factory Pro jet kit
- 2005 250 ninja questions...please help
- AGM Battery for '93?
- Turn signals freeze
- What if the closing throttle cable snaps?
- New Kaw 250 Rider, Few Questions about bike maint
- Don't push your trip button in motion
- HELP! Bike will start but once put in gear dies
- I got 100 MPG!
- Centerstand all of a sudden contacting the exhaust?
- Installing New Brake Pads
- More Tire Questions
- Removing Rear Wheel?
- 2003 charging issue
- 250 clutch issues
- Intermittent lean-feeling spot
- Papa needs a new pair of VROOM
- having alot of problems :(
- Air Filter
- ANY ONE HAVE A RUN(on a dyno)with de-baffled cans?
- so.. ninja lowsided... questions about fixes!!
- Small surge a cruising speeds.
- RPM's on highway-a little high?
- Pirelli MT 75 life span = short
- Please help me trouble shoot!!!~~~
- Clutch Sticks
- Sputtering in powerband?
- Upgraded the horn on my Ninja
- I don't think this is going to end well...
- Dude are you freakin serious? Rear brake problem.
- Hard ticking at idle
- Help!!!!! Clutch cable needed!!!!!!!!!!!
- Bent footpegs, replace?
- More room at the foot pegs?
- Speedo Came Off!
- Sea Foam = Miracle Worker
- cold start-bike dies???
- seat recovering ?
- Running hot or normal?
- rear suspension
- Exhaust hits the swingarm -
- Winterizing...
- New sprockets
- Idle hangs when rev'ing engine.
- Bike running too cold? Is that even possible?
- How much PRESSURE can you handle
- Front right blinker doesn't come on but light on console blinks super fast
- Aftermarket Clutches, do they exist?
- First ride on my $500 Ninja! Need some input.
- Help me pick out a rear shock...
- Which pod filter do you use?
- best way to seat the air box to carbs.
- Dead clutch or Newbie problem?
- what's your worst gas mileage?
- Muzzy exhaust $150
- small hole in vacuum piston which way do they point?
- My 2005 EX-250 with fuel injection....
- Winterization complete......
- What kind of chain?
- Need New Fairings
- Fast blinking turn signal
- Tuned my Jetting with an EGA
- Brake Fluid?
- soft spot between 6k-7.5k RPM
- Clutch basket q's *searched*
- Future problems??
- Aftermarket exhaust
- 1988+ Ninja EX250 FULL Wiring Diagram here!
- Where to buy Piston Rings?
- Question about newer model fairings
- quick fix is turning into a project
- Galfer Brakes?
- Officially tired of nose dive...
- Engine mount nut size?
- Anyone using Two Brothers Exhaust with Silencer Tips?
- I guess I'm gonna hafta do this myself!
- Poor running no more!
- 08+ exhaust on a 07?
- Engine hanging at 4000RPM
- Have a lean issue with my bike, issue with coasting enricher.
- Downgraded. Or upgraded?
- 2 to 1 exhaust?
- Ease of Replacing the Motor?
- installed battery backwards
- RedLine Fuel System Cleaner...
- Turn signals not blinking
- Pod Filters and Jetting Question
- Kills & won't restart.
- voltage when running
- bike won't start :/
- Ninja 250 flat spot
- Exhaust and turn signals
- Help 96 ninja 250 issues
- Trying to pin point an oil leak
- rear tire
- what type of gas is good for 250 ninja
- Different jets/needles?
- HID Conversion for Pre-Gen on Ebay/Link..
- jet question
- How to install HI/Low HID bulbs into a pregen ninja
- tune up
- radiator fluid
- How "optimistic" is your speedo?
- 07 250r spitting fuel
- bar ends
- motor work...
- 2004 Ninja 250R electrical problem.
- stock exhaust
- Carb question
- HELP: odd fuel issue
- Carburetor Heads Up
- Carb question
- removing baffle from stock muffler
- carbon parts
- 07 ninja carb. and intake?
- storage
- Pre-Gen Tire Preferences....?
- carb fitting
- Yoshimura 2-1 Issues
- Paint codes
- 500 miles
- bike wont idle
- drain gas from tank
- HELP. Cant get bike to start
- starting bike
- 2001 ninja 250
- Just performed my first valve adjustment
- Rear suspension
- stock headers
- Foam grips... should I keep them on?
- Front Brake rotor
- Idle jumping