Forum: 1986 - 2007 Ninja 250R Tech Talk
April 18th, 2012, 04:15 PM
|
Replies: 8
Views: 2,539
|
Forum: General Motorcycling Discussion
April 18th, 2012, 04:10 PM
|
Replies: 53
Views: 2,877
The bike is fine for the freeway. I have a Moto...
The bike is fine for the freeway. I have a Moto Guzzi 1100 LeMans, and I'm used to big bikes (FJ1200, FZ-1, VFR750, FZR1000), and my wife's ZZR250 (same basic stuff) pulls hard up to 160 km/h (100...
|
Forum: Motorcycle Gear
April 18th, 2012, 03:54 PM
|
Replies: 21
Views: 4,323
I bought a two piece A'stars suit thinking I...
I bought a two piece A'stars suit thinking I would wear the jacket only for short trips... did not work out as the jacket was way too short to work on its own without being zipped to the pants, but I...
|
Forum: Motorcycle Gear
April 18th, 2012, 03:48 PM
|
Replies: 41
Views: 4,323
|
Forum: Motorcycle Gear
April 17th, 2012, 07:36 PM
|
Replies: 22
Views: 2,275
If you do get headaches with earplugs, try...
If you do get headaches with earplugs, try different styles. My personal faves in a helmet where the ears get squished a bit are the really soft 'low pressure' ones like the LaserLites but everyone...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
April 17th, 2012, 04:09 PM
|
Replies: 6
Views: 1,774
|
Forum: General Motorcycling Discussion
April 17th, 2012, 03:08 PM
|
Replies: 13
Views: 1,202
|
Forum: Motorcycle Gear
April 17th, 2012, 03:03 PM
|
Replies: 22
Views: 2,275
I normally ride wearing a set of the Howard...
I normally ride wearing a set of the Howard Leight LaserLites, I buy them by the box and keep them stashed everywhere as they are low pressure and comfortable (unlike the round EAR foamies that hurt...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
April 17th, 2012, 02:45 PM
|
Replies: 6
Views: 1,774
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
April 12th, 2012, 04:33 PM
|
Replies: 10
Views: 4,901
Update on this I went with the Avon AM26...
Update on this I went with the Avon AM26 Roadriders in stock size in the front (100/80-17) and one size down (same as the new 250r) at 130/70-17 in the back to lower it a bit (wife's bike, she's...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
April 10th, 2012, 11:43 AM
|
Replies: 161
Views: 39,477
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
October 18th, 2011, 10:04 AM
|
Replies: 32
Views: 5,905
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
October 17th, 2011, 10:57 PM
|
Replies: 32
Views: 5,905
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
October 17th, 2011, 12:31 PM
|
Replies: 32
Views: 5,905
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
October 17th, 2011, 12:16 PM
|
Replies: 4
Views: 1,527
*SOMEWHAT* interchangeable. The head pipes will...
*SOMEWHAT* interchangeable. The head pipes will bolt up and the general elevation of the mounts at the rear will be correct, however the ZZR/EX250H is wider at the swingarm and rear, and the leading...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
October 17th, 2011, 11:58 AM
|
Replies: 20
Views: 3,627
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
October 15th, 2011, 09:57 AM
|
Replies: 17
Views: 2,616
I never get even close to 31K out of a set of...
I never get even close to 31K out of a set of pads, but traffic here in Vancouver is a whole lot worse than in Quesnel where Calvin lives. My guess is that he doesn't do a whole lot of stop and go...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
October 14th, 2011, 10:25 PM
|
Replies: 17
Views: 2,616
Factory pads on this bike are sintered. Any...
Factory pads on this bike are sintered. Any organic pad, no matter how good (Even the EBC Kevlar pads) is a big step backward. All you are getting with the EBC HH's is a sintered pad with a little...
|
Forum: 2008 - 2012 Ninja 250R Tech Talk
October 14th, 2011, 08:03 PM
|
Replies: 17
Views: 2,616
|
Forum: !%@*#$%!)@#&!%@ I crashed!
October 11th, 2011, 10:21 AM
|
Replies: 53
Views: 5,877
You can just pick the bits out or blow it off...
You can just pick the bits out or blow it off with compressed air, and squeeze any excess oil out of it (I put a paper towel over mine and press)... the oil won't hurt it unless it's soggy and...
|
Forum: General Motorcycling Discussion
October 7th, 2011, 10:45 AM
|
Replies: 34
Views: 4,875
|
Forum: Motorcycle Gear
October 5th, 2011, 12:19 PM
|
Replies: 35
Views: 3,192
I'm with you on pretty much everything here. I...
I'm with you on pretty much everything here. I do take claims like the 20% (unavoidable???) damage each time with a big (BIG) grain of salt as that's a heck of a tough thing to quantify, and I think...
|
Forum: 1986 - 2007 Ninja 250R Tech Talk
October 5th, 2011, 11:37 AM
|
Replies: 10
Views: 4,901
Ahhh, never mind on the Sport Demons... I did...
Ahhh, never mind on the Sport Demons... I did find some great writeups on them but they don't make them to fit the front on the ZZR - 100/80-17. While it might be possible to squeeze on the 100/70...
|
Forum: !%@*#$%!)@#&!%@ I crashed!
October 5th, 2011, 11:01 AM
|
Replies: 53
Views: 5,877
|
Forum: !%@*#$%!)@#&!%@ I crashed!
October 5th, 2011, 10:49 AM
|
Replies: 53
Views: 5,877
|