March 8th, 2019, 04:34 PM | #1 |
ninjette.org newbie
Name: MC
Location: USA
Join Date: Mar 2019 Motorcycle(s): NA Posts: 9
|
2010 Ninja 250r Project Won't run without Choke
Hi I know this has been talked about a lot, but I recently bought a 2010 Ninja 250r with 700 aprox miles on it for 850. It has an issue where the gear where the starter connects to the fly wheel gear case hole broke, but I just removed that gear and put new oil and coolant in it. Anyway I knew the bike had been sitting so I stripped down the carbs ultrasonic cleaned them make sure all the jets were clear and put then back in. Went to start the bike and it started on choke and idled around 7k rpm but when I tried to turn the choke off it died on me even after letting it warm up for a good while. Just took the carbs off again and looked in there and everything was still clean and no clogged gets or stuck floats or anything! Looks NEW! Biggest thing is some vacuum hoses were missing when I got it so I'm not sure on some of the hosing and that might be what is causing it not to run. Any suggestions?
|
|
March 9th, 2019, 07:37 PM | #2 |
ninjette.org certified postwhore
Name: AKA JacRyann
Location: Mesa, AZ
Join Date: Dec 2011 Motorcycle(s): CB125T CBR250R-MC19 CBR250RR-MC22 NSR350R-MC21 VF500F CBR600RR SFV650 VFR750F R1M ST1300PA Valkyrie-F6C Posts: A lot.
MOTY - 2018, MOTM - Nov '17
|
How far did you disassemble carbs?
Enough to floss out fuel-circuits and bleed-holes in emulsion tube and pilot jet? https://www.ninjette.org/forums/show...39#post1242539 |
|
March 9th, 2019, 08:37 PM | #3 | |
ninjette.org newbie
Name: MC
Location: USA
Join Date: Mar 2019 Motorcycle(s): NA Posts: 9
|
Quote:
|
|
|
March 10th, 2019, 07:15 AM | #4 |
ninjette.org certified postwhore
Name: Gordon
Location: new york
Join Date: Sep 2009 Motorcycle(s): '95 DUCATI 900SS/SP '07 DUCATI SS800 '19 HONDA CBR650R Posts: A lot.
MOTM - Nov '18, Mar '17
|
where do you have your pilot screws set?
__________________________________________________
Custom Carb Service |
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Won't run without choke and dies when given throttle | Kryptykcloudz | 2008 - 2012 Ninja 250R Tech Talk | 32 | July 20th, 2021 10:33 AM |
2009 250r won't run without choke | Bonereviver | 2008 - 2012 Ninja 250R Tech Talk | 8 | February 3rd, 2014 08:00 PM |
Won't "run right", won't idle, choke only, etc?? - SOLUTION HERE | Jiggyfly | 2008 - 2012 Ninja 250R Tech Talk | 5 | May 16th, 2012 09:50 AM |
Oil rapidly filling airbox, won't run without choke. | 44chart | 1986 - 2007 Ninja 250R Tech Talk | 21 | March 28th, 2011 09:13 PM |
Ninja 250r Wont Rev or run without choke | esde | 1986 - 2007 Ninja 250R Tech Talk | 21 | November 9th, 2009 02:32 PM |
|
|