Quote:
Originally Posted by Hasersys
Newgen swingarm swap, and gsxr600 shock mounted. What are you doing for a swing arm.
|
Sounds like a good setup, running a zx600r swinger - 1992 I have to narrow the pivot mount by like 1/2 inch. May be able to get away with reusing the stock zx600 needle bearings by pounding in deeper- the factory machined about 3/8th deeper than necessary on each side. The pivot bolt on the zx is 17mm vs ninjette's 15mm, thinking about boring out or using some bushing adapters.
this aluminum zx600r swinger pic is borrowed from @
verboten1