Final fit on swinger done, I put the swivel end into a toaster over to expand the swinger and then fit the brass bushing, then put the swinger back into the oven after I trimmed the bushings to fit to expand them and bang the smaller bearings in. Fit is good.
I had to get some bead sealer to get a good tire seal, so that is done. I chose the tire heights to be as wide as possible and still match height-wise front to rear. Now have to balance and polish wheels. Waiting on new brake caliper seals and also muffler has been selected to be ordered.
As to the tank, I am playing around with this gutter guard material to fill in the tank indentations where the fairing used to go- it's going to be painted flat black. I have a few more ideas if I change my mind.
Some bike pron