- Leak on right fork seal
- Shell Rotella 6T Question...
- Gas fillup and chugging on reserve
- Newb Troubles
- Does my pre-gen need the diode mod?
- Lower triple clamp
- gps'd my 2006 speedo, still uncertain
- Spark plug tool - check/change plugs
- Transmission question
- Carb cleaning...Engine revving High
- 2006 250 Chain & Sprockets
- Is there a DIY on piston rings?
- valve adjustment tool is it necessary?
- Rear Brake Lever Travel is Excessive and Rear Brake won't Lock Tire.
- Old review and general chat
- cranking problem
- Need Help Oil,engine rebuild
- Attaching lower front faring
- Ninja having clutch and shifting problems
- what are these called?
- Valve adjustment help
- Question
- Pregen fairing modification
- 08 carbs on 07
- Just bought used 2004 Ninja
- What material are the pegs made out of?
- Clutch problems
- Valve adjustment, carb clean, carb sync?
- Carb screw allen head replacements
- valve cover gasket
- Brake pads
- plastic protecter
- am i screwed or what?
- My 250 is doing the same as everyone else's that sits a while. With video this time
- Lowering the 250
- idle issues
- air/mixture screws factory setting
- Just bought a 2007 Ninja 250 R with 15k miles...1 issue perhaps!
- Brakes
- Loud knocking at idle
- Just installed new gen rear wheel, brake problem?
- Question about throttle
- Shifting Issues
- my kawasaki ninja 250 2005 won't start
- Need advice and my theory about intermittent running
- Surging mid RPMs
- carb throttle bracket mount broke
- failed inspection?
- Carb swap, setting mixture screw
- 1986 ninja 250
- Carb Needle Shim Question/Bike Idle
- Do I need a new front rotor?
- so how do i replace my license plate light...?
- Still lovin this stupid little scoot
- Trail Tech Vapor Review
- Won't roll in gear with clutch squeezed
- Another stuck gas cap! HELP! :)
- Will a 08-12 Engine fit in a 07 Ninja?
- battery
- odd surging
- 6000 RPM Idle Dies with Throttle
- Carb Issues: you're not alone.
- How to identify cams?
- My 2006 Kawasaki Ninja EX250F.
- Carb question: High RPM hesitation
- 1986 EX250 Fairing Repair?
- Hit a wall and need some help PLEASE
- Engine swaps.
- 1986 EX250 Fork Tube replacement?
- Carb Disassembly Q
- exhaust swap ????
- Hardware Size Spreadsheet?
- OVERHEAT
- Three Position Headlight selector switch?
- radiator FAN SWAP
- Best method to break off stock 250 clutch perch
- Need insight in sparkplugs
- engine knock?
- Is the stock clutch lever compatible with the ex500 clutch perch?
- Evap Removal..
- Breather hole in block..??
- 2007 no spark
- What the heck is this thing by my shifter?
- bending rear peg brackets??
- NOOB and I need help please.
- I need help!!!
- 1999 Ninja 250r - When riding front wobbles/feels loose
- Brake Question
- What to do about rear blinkers?
- 2007 Ninja EX250 Shuts down at 70MPH - PLEASE HELP
- A little help with my carbs?
- Top Speed?
- Need some help!!
- carb clean and shimming 86 ninja 250
- clamp around airbox to carbs
- Shifting issues when warm
- 01 Ninja250 not starting properly
- headlight issues
- adjusting idle mixture screws
- Need Help Wiring In New Led Tailight
- service manual
- Horn and Brake Light not working
- Need help with a shifter issue
- Left handle bar controls change 87-07
- 2006 Ninja 250 High Idle RPM
- headlight bulb
- headlight issues
- Considering a 250 for my daughter-Center Stand Mods?
- Thermostat Question
- changing oil
- fuses and junction box
- Advice needed on engine work
- 65MPH Tops 2007 Ex250
- Hotter when naked!
- New-gen shock on pre-gen
- How to sell
- Service help/advice
- Won't start
- Help fishdip destroyed my bike!
- Upper fairing/windscreen bolts
- No cover, no seat, been raining, and I'm away on a work trip...
- Headlight Modulator Advice
- what is the diameter in the fram under the seat?
- bikes throttle sputters at WOT
- Oil Filter Questions
- Slip-On Exhaust
- any help id'ing this 2 into 1?
- Petcock pickup tube length??
- Please help, oil in air box.
- Anyone know the difference between the CA and US flywheel?
- Coolant Reservoir disconnected hose
- Easiest way to obtain this side cover grommet?
- Low end power??
- Bike feels "wallowy" in high-speed corners +Brakefade
- Need help asap with float needle height
- right hand grip twisting indep. of throttle
- Taking apart transmission, need an advice
- Brake Rotor Options... ?
- 89 ninja 250r motor swap to 500
- How high the needle?
- Gas in Crank case sight? (The hole where you see 2T)
- Noisy Top End
- Issues with my bike, trip in only 3 weeks help!!
- Engine Teardown and Rebuild
- Building 2 into 1
- Say I wanted to raise the tail 3".... Shock and dog bone size recommended?
- Moto leaking gas
- Leaking Gas Tank
- Vibration while idling.
- Fairing Repairs with PlastiFix
- Intermittent charging system failure ugh!!!
- Missing piece to my master link?!
- Front fairing seems loose.
- In the dog house!!!
- Rpms won't go any lower than 2k ....
- Pretty sure I blew up a cylinder (?)
- Small puncture in tire
- Clutch cable routing and cover.. NEED HELP!
- Long cafe racer seat?
- Feeling Squirmy
- Changed the oil now it shuts off when idle.
- !!CLUTCH ISSUES!! need help!! actuator/bolt will not engage
- Bike got wet in the rain.
- Tiny oil leak
- Brake Light Issue/Front Master Rebuild?
- Bike won't run above 5K rpm
- 04 Ninja 250 - no taillight, brake light circuit still works
- Maintenance schedule excessive?
- Headlight question
- Would you recommend this chain?
- 2004 Ninja 250-r for 900$
- Upgraded front suspension, front end tuck
- Rear tail light not working.
- Bike hates the cold starts.
- Carb Issues...? HELP
- My clutch: burning more than a bladder infection
- Idle issues - Idle is different every time I start up.
- RPM needle jumping
- Broken throttle cable
- Bike for sale, thinking of buying it.
- Alternative Carbs ?
- Unresponsive throttle (2007 Ninja 250)
- Broken rod and crankshaft
- How long do you go between new chains?
- Jump started backwards
- Ninja into cafe/brat Project...
- What do you get when?
- A little help please...
- Removing Rear Shock Spring?
- Exhaust leak on the right side
- Necessity of Gauge Cluster?
- New Issue...
- Lots of oil change questions.
- Trail Tech Vapor Idiot lights
- How exactly does neutral work?
- Parked bike fell in mud and now idles low/won't start.
- Help plz!
- Strange high idle issue.
- Gutted harness issue
- Ninja wont stay in 1st when engine off
- Factory Service Repair manuals? Which one?
- Delayed Tach
- First Time Maintenance
- Throttle not dropping
- A plea of HELP from a newbie!
- There's rust on dust on a frog on a log in the hole at the bottom of my tank
- Ecotrons petcock option
- Turbo install
- An electrifying question...
- Bedding in the brakes way faster
- 1986 Ninja 250 Update
- floating rotors?
- sluggish acceleration
- Vacuum-Less Petcock
- sta-bil?
- Shopping for my Ninja
- Refurbishing an old battery
- Low and bouncing idle...
- bORED? how much the swinger weighs
- Clutch Issues
- Bike fell over (again lmao) and won't turn over
- 2-Stroke Ninja 250
- Starting Issues
- Smoke from exhaust
- How to replace the throttle cable?
- Replacement Spark Plug Removal Tool
- Strange Fueling after Carb Clean
- Installing New valve stem
- Gixxer shock on a pregen (with pics)
- Low oil--->Killed engine--->What happened?
- Does this look good?
- How to clean the crankcase, and airbox without disassembling
- thanks everyone and i have another question
- Please help with my new bike
- Neutral Light/Safety switch not working help.
- Help! Blown motor!
- unsteady idle
- keeps stalling out
- Winter Withdrawal
- need help but i know im going to sound like an idiot
- Seat falls off!
- Confusing electrical problem
- Please help troubleshoot my 04 ex250!
- Another Tire Thread!
- E-85 on stock engine
- Jetting/Needle height adjustment question ninja ex250
- Kickstand Kill switch - Inert
- A thank you and a funny tech related story
- Clutch plates stuck?
- Changed out spark plugs after winter. Give gas and dies.