- Kleen Air system
- 1st gear locking
- 4000 Mile Maintenance.. have you done it?
- Need help installing front turn signals
- Thanks for the DIY Threads
- race body
- Frame Sliders Opinions Needed
- HIDs
- LP light
- Can't find thread, seat grinding/lowering
- 2 Bros Slip on Exhaust Question
- Trick Star Rearsets......jdm
- DIY- Area P Quiet Module Install
- Oil change
- jetting
- Rear suspension adjustments
- 06-07 GSXR exhaust swap question.
- 24.5 instep. challenge to find a bike.
- Choke every time?
- Question for all the Ninja owners
- Brake light works but tail light doesn't
- Slow inaccurate gas guage
- HMF slip on misalignment
- Jetting Question
- Master Cylinder woes....
- need some help
- Which exhaust do you have and why?
- Hmmmm, haven't seen this issue yet ...
- Rear brake pressure
- Steering damper for 08 Ninja 250R
- Shifter Noise?
- Crooked handle bars
- 2008 - 2009 any changes?
- gearing for maximum acceleration
- pods
- Crankcase ventilation overflow tube?
- Race Tech Fork Springs
- Are these the right size?
- Gas Smell
- Random tube sticking out of bottom
- super tight countershaft nut
- Steering seems loose??
- Suspension Question
- Clip-ons or Rearsets... Rearsets or Clip-ons...
- GSXR Exhaust on the 250
- Upper tail fairing part number?
- Exhaust Temperature
- Rear shock
- Pre-load adjustment settings
- Good place to buy?(mirror extender)
- Front Tire Torque
- Coolant Leak
- little by little
- hyperpro damper
- steering head screw size
- Man the ninja is light!
- Power band after mods....
- Couple of questions
- Ninja 250SE
- datatool digital gear indicator
- Front Cowling
- Rich or Lean?
- speedometer gauge light bulb?
- fairing / windshield (???) buzz
- I C ignitor
- Rejet?? Dyno jet?
- 250r Popping Out Of Gear
- hard to start
- Hard starting... tight valves?
- suggestion on common tech tip
- Header exhaust gasket
- Scorpion Stainless Steel Exhaust
- My work in progress
- Gap between windshield and fairing
- Fuel Smell+Dropped it
- To dyno or not to dyno
- Wiring up for GPS
- crap in oil?
- Exhaust Suggestions
- 2008 owners manual
- FI model - Need some help and information
- DIY: 600 Mile Service
- Tire Pressure Question
- Dad broke the screw on my kickstand killswitch
- max tire size?
- rust rust rust
- Competition werkes exhaust
- Yoshi Exhaust question
- Oil Recommendation for Summer riding
- comp werkes fender kit trouble
- Technical: Cush Drive on 2008 Ex250R
- Power Commander - Full Yoshimura - Dyno results
- HR-1 Exhaust Question
- Stand best used for front end alignment?
- Loud, Cool, Horsepower Goodness
- Lowered/shortened Kickstand
- Re : R&G Aero Crash Protectors Kawasaki ZX250 Ninja 250R '08
- Rear Axle Nut
- Battery Replacement at 3,400 miles?
- 2008 speedometer bounce???
- Noise from front wheel
- two bros slip on
- Crash protectors/frame sliders
- hesitation?
- New rider, stupid question.
- first oil change?
- M4 exhaust this time!
- Gas gauge fix
- Would you rather
- DIY - How to Reshape Your Seat For More Comfort
- crashed my bike a couple of weeks ago
- best tire combination for 08
- Voltage regulator over charging
- More power goodies? Sounds cool to me
- Will a 16t sprocket hit the cover?
- Parts install?
- Rim Stripe Tips: Anyone?
- What do you think of my tire wear?
- Very high revs with choke
- Scratch repair
- Just a friendly reminder about your shifter
- Pirelli Sport Demon Tire Upgrade
- 07 signals on a 08?
- Sport Exhausts and Catalytic Converters
- Part number???
- front tire tilted?
- Power Commander Map Needed
- upshifting noise, need some help.
- removing snorkel + rain?
- knocking or rattling noise
- 250 experts....need help
- Lowering a bike further with 16' rims???
- Question for Clip on users
- Keeping a Maintenance Log Book
- Question about oil viewing glass.
- 1st oil change - not so well.
- Lubing the chain after washing?
- Rear set adjusters...cheap!
- Changing Gears, 3 to 4 sticky
- Dynojet/Factory Pro
- Don't forget to check the wiki!
- IC Ignitor issues & power loss
- DIY - $0 Fender elimination
- Exhaust Hangar/Rear Peg illiminator
- 7500 mile Service. Anything else?
- Affordable rear shock? We got em
- Rust on front brake rotor?
- tach replacement
- Whats your 250 MPG?
- Hanging Idle
- will this harm my engine?
- 2008+ - What's your MPG?
- Shift Problems
- Footrest dimensions from New Gen to Pre Gen
- Munchkin handed lurker with a question
- How much fork tube above triple?
- Dropped it like a tool
- replacing bulbs in ninja 250r
- Strange noise from engine after tightening chain
- Too much oil bad?
- Is jetting THAT much better than shimming?
- Mixing maintenance plans and oil preferences
- 08 fuel cut out problem
- confused about air filters amongst other things
- Clean air gone! Question though.
- Loose tail light because of tape?
- 600 mile service.
- whispering sound
- HID bulbs + Headlight modulator? Will it work?
- Chain Slack?
- how long do brake pads generally last for
- SS Brake lines?
- Re shimmed...worse cold start?
- Picked up my Ninja today from the Dealer...
- Lift Suggestions?
- Shimming the needles question
- Spools That Actually Fit? Lets End The Confusion.
- Thunder Powerjet
- Urgent~ advice regarding Break in with semi-synthetic Oil
- Idle mixture screw question after jet install...
- I have the most expensive frame sliders...and they protect the body!!
- Help
- It made the most awful sound after startup.. :(
- Bar End Weights For Clip-Ons??
- shaky
- Badly scored rotors
- Changing gear shifter to GP style?
- New Gen Tire Mileage
- Whats the Shelf-Life of Oil?
- Oil & Temp light staying on longer at start-up
- Clicking from Left Handlebar Area
- Slipping shift pedal tie-rod
- Less than 4k mi. on '09 ninjette . Battery already dead
- Disposable air filter?
- Rear end feeling squirrelly
- back tire slipping/clutch slipping???? help?
- choke lever
- Spikes Sticking outta Ninja Body?
- Ninja 250R Crush Washer Size/Specs?
- rpms
- Cali model emissions stuff..
- extra oil?
- Anyone change oil weight for summer?
- 91 ex500 rear sprocket on 250r?
- Removing Carburetors?
- Two Brothers Slip On Pipe
- Another carb question
- changing brake pads
- 30+ hp
- Touch Up Paint From Your Hobby Store
- Front end lowering kit for sale??
- What is the max speed of your bike?
- Rattling Noise from 8-9k RPM
- Difference between the turn lights??
- uhh, bike wont start.
- Shimming mod complete, question!
- Chain loose question
- Recall Notice - 2008 Ninja 250's
- How long is the ninja?
- Changing my fork oil-- suggestions?
- Oil level sight glass
- tube for brake bleed
- Shifting changed with new oil.
- Slip-on question
- Ninja 250r release comp clutch issues
- 150 tires
- So funny story...
- Rev meter Problem
- Do I need to rejet because of move??
- DIY- Replace fork seals, dust seals and fork oil
- Stripped oil pan
- Emissions
- Fram oil filters
- 09 ninja tachometer
- Problems running, seems very rich?
- head pipes
- I did my 1st oil change question!
- How does one unscrew tight spools / bobbins?
- Could someone create a DIY for oil pan removal?
- fuel position question
- I need some measurements please.
- slip on or full
- Newbie can't downshift!
- Tail Light On The Fritz
- Worried about my 2nd oil change...
- -1/+2
- Keeping the bike cooler...
- Hitch Pin for rear Axle nut?
- Thread pitch and size for Spool bolts
- Oil Leak on 6 week old bike, less than 100 miles on it