- cam chain tensioner
- Shimmed needles, now have idle/RPM issues.
- knocking sound
- chain issue
- spark plug replacement during other work?
- Wiring LED Strip question
- Alternator Wire Gauge
- Rivet instead of screw on fairing?
- Help double check my Snorkel/Shim/Slipon logic
- Fuel set to PRI?
- Underside covered in sludge/oil
- Headlight out/fuse blown...
- front brake line upgrade questions
- Building a custom 18" slip on muffler.
- rpm issues on 2012 ninja 250
- Spooph's 250 build thread
- Stupid Schematic
- Starter motor clutch
- Recently Rebuilt - Engine Cranks but won't start
- Gixxer front end swap
- Ic ignitor or tach issue and dealership
- clutch pressure plate torque
- Electrical problems
- Suggestions for a 15T front sprocket?
- Getting rid of stubborn rust in the chain...
- Lithium batteries?
- bellmouth diameter?
- my dumb assary may have paid off.....or not (battery problem)
- Need Visual Confirmation of Carb Hose Routing
- 2012 250 not getting gas? please help!
- Question about tires
- Speedo not working
- Maintenance schedule?
- Motor leak?
- Help, fuel leak.
- Chinese rear sets from ebay!
- Swerving
- Rear caliper allen key bolt stripped
- emulators
- Removing spark spark plugs?
- Track day, Race starts and a funny bike?
- Throttle Response Dies Around 7-10k rpm + a few noob questions
- Best/Cheapest Place to buy tires
- 09 ninja 250 cleaning sight glass
- 2012 Ninja Tire Suggestion
- Can a shifter like this be used on our bikes?
- Headlight Wiring Q
- Is it a huge issue not to use anti seize on spark plugs?
- Downshifting Probs
- How to know if rotors are warped?
- Best Brake Pads?
- Can't have throttle wide open when riding
- Need some advice...
- I did something bad... ;(
- How to know if spark plugs are tight enough?
- How low can brake pads get?
- starter idle gear
- New Problem - Broke heads off two clutch spring bolts
- Thinking of buy a brt Tis?
- Has anyone ever actually has an issue with Fram?
- Is this normal after jetkit install
- Ignition timing upgrade
- Need help connecting a vacuum hose
- Bike bogging when giving it throttle
- DIY - Carrying extra fuel
- Old gas
- Questions about Replacing Chain/Sprockets
- Left rearset install issues
- Pre-gen kickstand on new-gen?
- Would you do your valve adjustment?
- Stainless bolts
- Can I need to cut/break my chain to replace the sprockets
- So do I need a new tire? Tires?
- Eliminating rear fender...
- Oil Contaminated after Rain
- Clip-ons above the top triple tree
- Tach stopped working?
- Help! Don't want to get electrocuted!!
- Valve adjustment problem!
- Bike turns off at startup
- Just noticed a slight issue with my tail light, need some advice.
- muffler bolt size
- Help diagnosing front end clunks and knocks
- Help with new bike revving very high
- headlight swap question?
- Help With Part
- New Tires - BT45 s or Kenda k671 s
- Loose chain adjuster
- 2009 ninja 250r engine ticking & knocking noise
- High engine temperature
- Did I just grenade my motor by going 1k over on the valve inspection?
- RPMS not working need help
- Gas level and sound issue
- issues starting bike in the morning
- Throttle Tube Replacement/Mod
- Front bolt / fork question
- 2008 vs 2012 service manual? And bike in general?
- Oil Change Failure. Help me fix this?
- Underneath the Block Off Plate?
- SS lines and bleeding the brakes
- 300 header pipes fit on a 250 08 and up.
- clunky while shifting heard?! advice please?
- Tires...
- This is an air filter???
- Lowballed on a Pre-Trade Inspection (Plus parts list)
- chain size after extension
- Torque Wrench
- Help! Won't run.
- Ninja 250r won't start
- Chain and Brake Pads - Opinions
- Stator Cover Replacment
- 2009 ninja 250 cct
- 2009 ninja 250 new engine
- Should I replace the petcock if it leaks while disconnected?
- Throttle Play
- A Gas Cap Problem Thread
- Snorkel Removal
- FI Ninja stalled - possible problem?
- Turn Signals ? nothing .... no blinking!
- You know you need to upgrade your ninjette when...
- New rear SS brake fit issue
- dog bone
- Another tach issue
- 7500 Mile Service
- carb problem
- 2009 Cafe Racer Project
- Low End Problems
- Clutch and Break Lever suggestions
- New sprocket installed - alignment? Coolant drip?
- Low Gas Mileage, why?
- 2009 ninja 250r carburator
- Suspension Adjustment for 2 up
- Valve Adjustment
- Which spark plugs?
- Need Help with Oil Problem
- I can't get my rear shock to adjust It seems stuck
- Bike died while riding on highway
- Side panels how to reinstall by seat?
- Bike won't start, cleaned carbs, new gas, backfires whats next?
- Headlight fuse - What all is running on it? 2009
- Fixed the idle, but rev it and it dies
- removing the ignition
- Bike wouldn't turn over. Waited a while then it started.
- Valve Clearance check
- Top 5 or 10 slip-ons?
- Flooding Engine at Low Throttle
- Getting CR8EIX Spark plugs to fit?
- 2008+ Ninja 250 Carburetor Screw size, allen screw size!
- 08 Ninja won't start after Gauge Cluster re-fit
- Interesting Talk With 2 Mechanics About The Engine
- sprockets
- engine swap
- Frame sliders
- bike leaking oil somewhere behind shifter, halp
- 09 metal vibrating sound at higher RPMs
- 09 shifts as easily without the clutch as with using the clutch
- swing arm swap
- Rear shock set to high (rear wheel slipping)?
- fairing bolt missing
- Won't run
- Gas gauge
- Ninja Leaking
- Speedo Problem
- Tail light flickering problem...
- Pulsating brakes?
- Shimming same with Jetkit Needles?
- Cable adjustment perch hole stripping
- Bought new triple with ignition but steering lock is on my bike
- Turn Signal issue, looking for opinions
- New Tires are Coming
- rpms dropping
- WTB 100's Jets
- Annoying noise at 2,5-5 k RPM
- Tug and pull feeling
- I'm confused......(tire question)
- bt45 140-70 H
- Anyone running a ninja 300 rear wheel?
- Lowering suggestions
- Bleeding brakes but lever doesn't stiffen after pumping?
- Help me please! Carb Removal (I'm Stuck)
- Can't get the swingarm pivot bolt out
- forks possibly bent?
- Brake Lever Angle
- What mods have you done to your 250r?
- Looking for Opinions on Arrow Exhaust
- Can't insert key all the way down into gas cap
- Headlight problem
- Whining Noise on Deceleration
- Clutch not fully engaging?
- 2010 250r Exhaust Discussion
- Bolt length issue for woodcraft rear sets
- Friend bent my clip on....
- Couldn't go any faster...
- Center Stem Bolt MISSING!
- HID Headlight Flicker
- swingarm spool bolt size?
- Replacing the fuel tank, different types?
- Rear light problem?
- Whats wrong with my baby?? Ticking noise??
- Fork dampening issues??
- 250R dying
- can i roll start a bike if lights are off
- Where to get a Manual CCT?
- Rear Shock Settings
- Topping up coolant reservoir frequently -- possible leak?
- 15t Sprocket Noise
- Different brand with an IRC front???
- Clutch Help
- Rearset help! :(
- Let talk rubbers! Wait, no, I mean rear seats.. wait...
- stock exhaust questions
- Temp light on gas gauge came on
- Positive Neutral Finder question?
- I crashed, leak at crash site
- Noise in transmission
- gap between throttle and handlebar cap
- My carbs are a PITA!
- 09 Keyless Ignition
- Left handlebar controls on new gen?
- 5 - 7 inch piece of bent metal on my bike
- Smallest possible front sprocket size
- question drop in filter or shimming
- Headlight/ cowling bracket
- Another way to remove the carbs....
- In a day or two, I'll know if my bike's repairable
- Stainless steel braided brake lines install
- Suspension doesn't move
- Anyone have the FMF Titanium slip-on?
- So I shimmed the needles today...
- Rocker arm mod
- Chain adjustment, now new noise
- Apex Stainless Steel brake line Install
- Stranded: Need help with ignition/battery
- time for new tires...
- Fuel gauge stuck at full
- Rear seat lock not working anymore
- Tools for valve adjustment
- Ordering parts by part number
- Odd choke problem
- What could this be?
- Where could it go?
- Is it bent ? .... that is the question.
- Need help with speedometer..
- Front rotor bolt replacement
- Horn only works when it wants to
- Here's a video that illustrates the benefits of a shimmed needle
- Unscrew carb bowls - tips please
- Throttle went while riding -> need new throttle cable?
- Tires
- Half gears around 3rd and 4th upshifting?