- Adjusting Steering stops
- Bar Ends / Grips for Clipons
- Throttle mod...
- Replacement Gas Cap
- Stock dog bone adjustment
- To choke or not to choke?
- 250 Won't Run for @$%T
- Turn Signal Problems
- Rear sets and clip-ons
- Proper way to align rear tire.
- Carb rejetting.
- bike lift vs stands?
- Quick question about gear shifter foot peg
- NINJA 250r 2012 - blown dashboard lights
- Few Noob Questions
- quick question before I head off to work
- Bike feels like its choppy
- Stalling on incline
- clutch cable part
- Help on adjusting idle screws
- Front right signal not working.
- Did my dealer just screw me?
- How Long To Change Tires?
- Brake light works, but doesn't work =/
- Engine Coolant
- Tank under pressure and bike wont start
- Bridgestone S20 Tires
- Carburetor Tuning - Rich and Lean Spikes
- Running on one cylinder. Not electrical?
- Hose loose?!
- Bike only runs on full choke!!
- Play / Clunk In Steering Stem
- Cleaning carbs. Need some help please!
- Bike refuses cooperate, need help!
- Best Method to Fix Bent Handlebar
- Turn signal question
- Bike shutting off on idle...
- Emergency: Need Help Changing Brake Pads (Oil Squirted Out)
- Overheating
- Bike dies with choke after not storing properly...
- Won't "run right", won't idle, choke only, etc?? - SOLUTION HERE
- Shimmed needles/removed the snorkel!
- Advice needed for basic mods
- Trouble Shooting a couple things
- bank angle sensor
- Just a quick question
- Using a 250 with no kick stand on the street
- Thought it was a rock..
- When did you get your ninja first serviced?
- Do I need to replace my entire carb?
- Don't Know What I Did Wrong, Tail Light
- Wheel Bearing?!
- Spool Install Question
- Is my wheel fixable?
- Two brothers install
- Need Advice: Stage II Dynojet Kit, Air Box Delete
- Jets to start with?
- Carb Diaphragm Accident!
- Anyone know how to make a silencer
- Can you tell me what this wire connection is for..
- Do both brake lines need to be stainless steel?
- Clutch feels wierd?
- shogun crash kit parts missing?
- stretched cam chain
- Headlight fuse keeps blowing
- headlight problem
- Tire brand choices for ninja 250r
- High Beam wont work!
- Trying EBC pads again.... mistake?
- Bent some metal and stripped some screws.. help me ha
- ninja 250 problem
- What tools do you need for your bike maintenance?
- Question about rear strut and rubber lines near mount.
- how to fix bent footpeg frame mount?
- Rear brake "sticky"
- Frame sliders - Install Help
- ECOTRONS EFI Kit Question
- Need help picking Fuel gas tank lock
- gas leak help please
- fairing rubber bushing
- Dunlop GT501G and GT501?
- dash led lights
- How long should my Oil tank be hot for after a ride?
- Bike EATS gas on highway
- Advice when disassembling calipers
- Problem with the alternator or regulator or electrical or all of the above?
- Replacing the Ignition Bolts
- Is this normal?
- Confirm Valve Specs on 2012 Ninja 250
- Something is wrong with my shifting lever
- N00b ? - I got rained on!
- where do I get the side panel bolts?
- Bad gas mileage and when should I get my 250 looked over at the shop
- Bike out of Storage!
- Snorkel Gasket
- removed the snorkel
- Carb/jet kit pictures
- Brake pads
- another jet thread question
- Turn signal fuse keeps blowing.....
- Brake Light Issue
- Speedo correction
- Leaking coolant
- Help! where does this wire go
- DJ Needles instead of shimming
- Turn Signal lights are acting like hazard lights
- Help!! Need advice... Bike Wont Run
- Yoshimura rearsets raiser help !
- Mods on Green Ninja 250 2012 Special Edition PICTURES
- Dino Oil
- Oil change
- Electrical Problem with brakes/starter
- Turn Signal Light Going Solid?
- General Maintenance
- TYGA Full Stainless Racing Exhaust & Fairing
- Long trip ahead
- Rearset Adjusters
- SixSigma Jet Kit
- Wheel alignment?
- So... Got my rear tire changed and...
- Question about removing stock exhaust baffle
- Looking for map...
- What different between Power Commander and Dyno Jet Fitting
- RPM Question
- 2012 Ninja 250
- Anyone have a K&N Air Filter?
- Oil top up advise
- 7k+ rpm makes strange noise
- First time valve help..........
- Carb Float Problem
- tire wear life for fat people
- Snorkel removal questions
- 2010 Ninja 250 Fairing Replacement
- my first post, i have LED problems!
- Issues at the track
- Fix Paint Scratches?
- Swing arm Removal
- Is the muffler supposed to shake a bit ?
- Brand new 250R.....wait for aftermarket parts or not?
- Local shops for front wheel issue
- shorty levers for small hands?
- Woodcraft Clip-on/Rearset Adjusters
- Strange sound
- electrical and charging
- 6 month old 250 w/2100 miles
- Need some help with camera mounting
- I don't know if you have already but.
- Can thinner oil cause engine ticking??
- Wheel Balance Product - Dyna beads
- Where is the reg/rec?
- Quick Question
- help plz. wideband afr fine tuning the carb
- question about shimming those needles
- Chain Breaker
- Help identifying bolts
- shimming fail
- Speedometer is dead on
- Do I Need To Lubricate It....
- Tire recommendations for NYC rider?
- Random questions about the bike - Are these normal?
- May anyone help me on this...
- Hot weather and the engine temp. light
- Best place to buy racetech product ?
- rewire headlight
- Proton lights with an integrated taillight help!!!!!
- Does anyone know...
- Fluid Leak After Drop
- Popping into neutral from first during slow turn
- Battery to choose
- chain lube frequency
- Adding a rivet master link to the stock chain ???
- Throttle Play Adjustment
- Dyno-tuning Results Two Brothers Exhaust
- High revs at stand still?
- wheel stand width question
- Question on (the thing..)
- Poor tires pt.III (RIP IRC)
- are these normal?
- Can I get away with a 104 link chain with stock gearing? If not, what rear sprocket?
- DIY FIAMM Freeway Blaster Low Tone installation inside fairing
- Danmoto Carbon GP Doesn't Seem Secured
- New engine direct from Kawasaki
- Kickstand switch...Pre-Gen CDI
- Safely remove paint from a chain?
- Will raising my suspension with shorter dogbones change my chain length requirement?
- Tube with amber stuff in it?
- Idle jumps to 9000 rpm on choke then wont stay idle after off
- Engine Issues: Bike Dies when given throttle?
- light went out on tachometer...
- 1st Gear, Low RPM Troubles
- Is there a DIY guide for...?
- throttle cable issues... plz help?!
- Is this a leak? Anyhow, I want it gone
- 10w-40 oil
- Handle bar set up! Help..help...
- Whats your idle?
- Slightly bent handlebar need advice!! Pics included
- Needing Some Tire Advice
- Clymer manual: Seems to exist; can't find it.
- Front fork oil change
- Dash lights
- Conflicting information about exhausts
- dash turn signal indicator
- Stupid bolt covers!!
- Cush Drive Shim
- Flat Spot in Power Band
- Unknown hose
- looking for help - noise
- overheating issue
- Bridgestone Battlax BT-003 OR Pirelli Diablo Rosso II???
- Slip on vs full exhaust
- Jet or Shim?
- Musarri Exhaust, Your thoughts?
- New Bike Issues
- Paranoid about idle, how does it sound to you?
- Delkevic DS70
- need help! weird noises
- Street PSI Question for BT-003RS
- Looking for a integrated taillight and found
- Quicky about 15t sprocket
- Anyone experienced this after shimming?
- general question about oil checking.
- Wouldn't go into gear?
- front vs rear sprocket change
- "Rim wrap" + thin rim tape as an alternative to powder-coating?
- Battery installation
- Running Lean or Rich? need help
- Anyone in San Diego have an oscilloscope I can borrow or help me use?
- Sputtering at high RPMs
- Front sprocket change DIY?
- Just bought used, what should I do to ensure a healthy engine?
- 2009 shimming
- Which battery Lithium/Ni/Acid/Gel ? Where did you buy yours?
- Sprocket set up?
- dropped my ninja 250 in a parking lot
- Riser bars CNC like OEM?
- Fork Problem?
- Fuel Gauge Question
- on slapping my ninjette with K&N air filter (KA-2508)
- quick question about clip-ons
- Question about rear brake spring...
- My brake lights :(
- EBC brake pads I'm picking them up tomorrow just want some fellow riders feed back.
- How to install yoshi slip on for 2012 250r
- Weird knocking noise...
- Big project planned... to me anyway, any tips or suggestions?
- bad battery or simply bad posture?
- Streetbikes Unlimited Frame Sliders Install?????
- Modifying the snorkel
- Bolt kit diagram